Intelligent zigzag cleaning path, planned and regularly, improve the cleaning coverage.

Voice prompt and touch screen operations. Just press CLEAN to start cleaning.

Dry Sweeping, Wet Mopping
The water in the water tank can slowly wet the mop to do the

mopping, thus improve the cleaning efficiency.
The design of water infection hole is accurate so that the water will creep evenly to the mop.

Auto Cleaning: Q7000 can adjust its cleaning routine automatically based on different floor types.
Spot Cleaning: Q7000 will spend more time in dirty areas.
Edge Cleaning: Q7000 will clean the edge and corner of the walls.
Zigzag Cleaning: A planned and regular cleaning mode.
Schedule Cleaning: You can schedule the cleaner to start cleaning at scheduled time.

The large size of dustbin enable the robot to clean a big area at one time so that you don't have to clean it frequently. Also the dustbin is washable to keep healthy and clean.
Filtering the Dust
The application of air purification standard to filter all the particles, making the air nice and clean.

2000mAH Li-ion Battery lasts long and makes low energy consumption. One-time cleaning can cover an area of 150-200㎡ in 100mins.

A.Check side brushes for damage or foreign object on the brush.
B.Clean the side brushes
C.Remove the screws of the side brushes, Replace brushes with

new ones, Use screws to lock the new brushes in place

Clean the sensors and charging poles per week or according to daily use to make sure the robot is well maintained.
Wipe the sensor window and auto charging sensors with a soft dry

cloth.
Clean charging contacts on self charging base
Clean vacuum intake and dust sensors as shown in the pictures.

Note: After taking out dustbin, check if there is foreign object stuck or block the vacuum passage and clean it if necessary.
A.Press "PUSH" to open the dustbin cover.
B.Take out the dustbin
C.Separate HEPA filter from dustbin.
D.Pull out dustbin top cover and take out primary filter.
E.Empty dustbin and wipe the dust.
F. Wash dustbin with water.

Clean filters with cleaning brush tool.
Note: Clean dustbin module when the trash icon flashes on the display panel.
Install primary filter and HEPA filter into dustbin.
Note: 1. Install both HEPA and primary filters when they are

dry.
2. Do not place HEPA and primary filters directly in the sun.
Close dustbin cover and install it into main unit.
Note: Dustbin and Filters( including HEPA and filter) could be

replaced if needed.

1.Open the water injection hole, after water injected, stick the mop

to the right place.
2.Aim at the relevant holes and assemble the trailing bar on the

cleaner.